WOPET F07 User Manual

Patrol Automatic Feeder manual. This edition uses Pet Zero; do not substitute the F07 Pro app or reset timing.

Read this web edition in English. Open or download the original PDF for the original document and any additional languages. Check the model, hardware revision and supplied instructions before use.

Specifications

Item	Manual specification
Schedules	Up to 15
Dry food size	5–15mm
Backup power	Three alkaline D batteries
App and Wi-Fi	Pet Zero; 2.4GHz only

Hardware installation and safety

Open the bottom battery compartment, connect the Micro USB power cable and route it through the wire guide. Install three D-type alkaline batteries for backup, then turn on the power switch.
Open the top cover, take the bowl out of the hopper and fit it to the front of the feeder. Add compatible dry food only. Do not add wet or damp food.
Battery-only operation disables Wi-Fi and app operations. The recorded feeding call plays only once before dispensing on backup power.
Turn off and disconnect power before cleaning. Keep hands and fingers away from the dispensing wheel. Inspect food and backup-battery condition regularly.
Wash the removable hopper and tray regularly. Do not fill the feeder body with water; wipe it with a well-wrung damp cloth.

App installation and network requirements

Install Pet Zero using the original manual’s QR code or the app store. Register or log in with the correct country or region.
Use a 2.4GHz Wi-Fi network; this manual does not support 5GHz. Passwords are case-sensitive. Use a compatible WPA / WPA2 network, rather than WEP.
Pair while external power is connected. Keep the feeder close to the router; a repeater or isolated network can interfere with setup. Check router access rules without weakening security for the whole network.
In Pet Zero, tap Add Device or +, choose Add manually and select Wi-Fi Pet Feeder. Allow the permissions needed for setup.

Pairing and reset

In normal / EZ mode, the red indicator should flash about twice per second. If needed, hold Wi-Fi Settings for 3 seconds until a beep. Confirm the rapidly flashing indicator, enter network details and wait for Done.
If normal pairing fails, choose AP mode. The indicator should flash red about once every 3 seconds. Hold Wi-Fi Settings for 3 seconds to reach rapid flashing, then hold again to switch to slow flashing.
When prompted, connect the phone to the feeder’s SmartLife- Wi-Fi network, then return to Pet Zero to finish setup.
The manual says auto-scan is not designed for this feeder. Use normal or AP mode.
To restore factory defaults, connect external power and hold Wi-Fi Settings for 3 seconds until a beep. Check all settings after reset.

Indicator status

Rapid red flashing: waiting for pairing in normal / setup mode. Slow red flashing: waiting in AP mode.
Steady red: configured for Wi-Fi but connecting or unable to connect. Steady blue: connected; the connected-status light can be disabled in settings.
Flashing blue: dispensing. The dispensing light cannot be disabled.

Manual and timed feeding

In the app, open the feeder’s main screen, tap Manual feed, choose the number of portions and confirm with OK.
Double-click the physical Manual Feed button to dispense. Set its portion amount in the app; setting the button’s feeding portions to 0 disables it.
To add a scheduled meal, tap +, choose the time, repeat days and portions, then save. The manual supports up to 15 schedules.
Toggle a schedule off to disable it. Swipe it left to access deletion.
Confirm the feeder’s time zone matches the intended local feeding time. Check actual food delivery with your kibble before relying on a schedule.

Voice recording

Hold Record for 3 seconds until the prompt, keep holding while speaking into the microphone, then release. Recording lasts up to 10 seconds; two sounds confirm completion.
Briefly press Record to preview. Record again to replace the message. Distance from the microphone affects recording level.
The default playback count is three, with settings up to five. Set Voice times to 0 to disable the call.
The manual describes different playback behavior on external power and backup batteries. Physical-button feeding does not play the recording.
If food obstructs the bowl, the manual describes a 10-minute pause with a call once per minute. Do not rely on pets to clear a mechanical jam; inspect the cause and disconnect power before clearing dispensing parts.

Feeding records, alarms and settings

Feeding records in the app cover the previous seven days. Enable notifications to receive low-food, low-battery or blockage messages.
Basic settings include battery status, connected indicator light and Reboot feeder.
Advanced settings include device information and time zone, offline notifications, device sharing, a home-screen shortcut and device removal.
To share access, register the second account in the same country or region and use Share Device.
The manual distinguishes removing a device from the app from clearing the feeder’s stored settings. Use the model-specific physical reset when a factory reset is intended.

Troubleshooting

Cannot connect: recheck external power, 2.4GHz Wi-Fi, password and encryption, then use the alternative pairing mode described above.
Wrong feeding time: check the feeder’s time zone. The manual instructs removing and adding the device again if the stored time zone is wrong; verify all schedules afterward.
Recording plays only once: check whether the feeder is on battery backup and whether a voice message has been recorded.
A bowl-blocked alert can remain after food is eaten because the manual describes a 10-minute observation period. Also check the food slot for a real obstruction.
An offline app on battery-only power is expected for this model; Wi-Fi and app operations are disabled.

Warranty and support

This edition describes a two-year non-transferable limited warranty for eligible Amazon purchases with proof of purchase. It lists defects under proper use and missing parts as covered categories.
Exclusions include purchases outside the stated sales channel, gifts without proof, tampering, abnormal use, accidental damage, replacements, parts and labor. It also lists 30-day return and replacement information.
The original PDF prints support@wopetshop.com for claims. For help confirming current eligibility or the correct contact, use the product support page and retain your order details.
For Amazon purchases: Your Orders → View order details → Seller name → Ask a question.

Regulatory notices

The source manual includes FCC Class B / Part 15 notices. Unauthorized changes or modifications can void authority to operate the equipment. The document notes that interference can still occur in a particular installation.

If interference occurs, the manual lists reorienting or relocating the receiving antenna, increasing separation from the receiver, using an outlet on a different circuit, or consulting a dealer or radio / TV technician.
Use the original PDF for the full compliance notice, including any cable and antenna requirements. Specifications and illustrations may change between revisions.